Working with recycled timber #73: Fish tank Stand Door Work Pt 3

Home / Working with recycled timber #73: Fish tank Stand Door Work Pt 3 - July 17, 2017 , by 54e8f7f6999ee8f9

TedsWoodworking Plans and Projects

After my crook leg episode I directed my activities to replicating the door for the center cupboard.

I set up the shaper to cut the profiles and did heaps of test runs before being satisfied that I could pass off a reasonable copy.

The trim bits


A lot off bench fiddling about went on until I was happy to go at the assembly

If found to get the best accuracy for both the bullnose and raised panel part I needed to cut the profile on a larger piece of timber and then trim it down.

Note the saw was not running when I took this picture

Then for the backing board I grooved a piece of ply to replicated the lap joints and screwed it on the back

Then I the cut each piece at 45 deg oversize and and then sanded it to a tight fit and then finalised the assembly by glueing the corners and spot glued the trim along the length.

Its a bit rough with a few waves in the raised panel section but should pass off as professional!!

Go to Source
Author:

Powered by WPeMatico

Related Posts:

  • No Related Posts